cutting composite decking with a straight edge

How to Groove Square Edge Deck Boards - FastenMaster

If you are using hidden deck fasteners, there may be occasions when you need to cut a groove into a square edge deck board. AZEK?? Deck; ?? Legacy; ?? Earthwood Evolutions??; ?? TwinFinish??; ?? Transcend??; ?? Select??; ?? Enhance??; Fiberon??

The Blog - 10 Tips For Building A DIY Deck

May 4, 2017 Trim Ends: Wood-composite boards straight from the manufacturing plant do not always have perfectly clean cuts. Karlson suggests you trim each end of the deck board before installing for a cleaner, squarer finished appearance. Start Outside: DIYers often begin with a full deck board butted up against the

Working with & Composite Decking - HomeTips

Apr 6, 2016 Expert advice on how to install and work with TREX and other composite decking materials, how to cut and fasten TREX, and framing for composite decking. A power miter saw can provide very accurate, straight cuts, and a table saw with support extensions can make all types of cutting easier. Carbide

Even up decking boards - Carpentry tips and tricks

What is the best way to cut and even up the edges of the decking boards after they are all screwed down in place, so we get a nice perfectly even straight line? Composite screws are really good, if they supplied you with a screwdriver bit that fits the screw heads then there are a couple of things you can do to make

Picture-Framing a Deck Professional Deck Builder Composite

Jan 1, 2011 Figure 13. Screw a straightedge along the inner edge of the picture frame, and butt the field boards to it. In some circumstances, it may be more important to line up the picture frame with a part of the house or a fixed object and then cut the field decking to fit within the border (Figure 14). Figure 14. Aligning a

Composite Decking: Installation Tips

You can cut composite decking just as you would ordinary lumber – with a circular saw. The sharp edges on the end cuts can be beveled with a belt sander. Cut each board square and have the joints positioned at the center of the joist. Use a jigsaw to cut out notches where a post or a downspout penetrates the decking.

How to Make Perfect Crosscuts and Rip Cuts with a Circular Saw

Cutting a straight line with a circular saw can be a challenge, but it doesn't have to be that way. Position the jig on a scrap board, hold the circular saw firmly against the fence of the jig, and cut through both board and one arm of the jig. This will trim off Hold the guide firmly against the edge of the stock, and make the cut.

Detailed Guide to Installing Composite Decks and General Information

Use our detailed guide when your next project includes installing composite decks. If you use a picture frame detail, you should start with the perimeter boards so you have a hard edge to measure for your field boards. Next, ensure your Butt joints need to be tight and this can be done with a square cut or a scarf joint.